Our model CA-1038 is a low cost 0.032in. diameter self-shorting pin with a 350 VDC standoff capability. Outer body construction is of Stainless Steel with brass cap (Previous brass version, no longer available). Lowest recommended pressure is 75 Kbars for 1E^-8 sec repeatable performance. Standard lengths are 1 to 3-inches. Other length are available upon request at an additional cost. Specify pin length, Lp, upon ordering. See model CA-1039 for convenient arrangement of pin, adapter, and cable assembly.

Our model CA-1042 is a low pressure self-shorting arrangement with 350 VDC standoff capability. Outer body construction is of Stainless Steel with brass cap (Previous brass version, no longer available). It is estimated that a minimum pressure of 150 psi. is required for adequate performance. Standard lengths are 1 to 3-inches. Other lengths are available at an additional cost. Specify pin length, Lp, upon ordering. For pins with a pin adapter and cable assembly arrangement, ask for model CA-1043 or CA-1043-C.

Our model CA-1058 is a self-shorting arrangement designed to operate in a side-ways motion mode with 350 VDC standoff capability. Outer body construction is of Stainless Steel with brass cap (Previous brass version, no longer available). Our CA-1058 will operate over a wide range of impact velocities. Standard pin lengths are 1 to 3-inches. Other lengths are also available at an additional cost. Minimum pin length is 3/4 inch, maximum is 3-inches. Specify pin length, Lp, upon ordering. For pin adapter and cable assembly arrangement ask for CA-1059.

Our model CA-1145 is a .125 inch-diameter self-shorting pin arrangement with a 350 VDC standoff capability. Lowest recommended pressure is 75 Kbars for 1E-8 sec. resolution. Standard lengths are 1-inch and 1.375-inch. Maximum length is 6 inches. Other lengths also available at an additional cost.

Our models CA-1039, CA-1043, and CA-1059 are combinations of our models CA-1038, CA-1042, and CA-1058 respectively with adapter and cable assemblies. Standard pin lengths for the CA-1059 and 1059C, are 0.75- to 3-inches and standard and cable lengths are 1 to 6 foot. Standard pin lengths for the 1039, 1039C, 1043, 1043C are 1- to 3-inches and standard cable lengths are 1 to 6 foot . (Minimum pin length 1/4 inch for an additional cost.)

For BNC cable terminator, ask for CA-1039-C, CA-1043-C, and CA-1059-C. For 50-Ohm line impedance matched termination ask for CA-1037, CA-1044, and CA-1060 respectively.

Our models CA-1039-SL and CA-1037-SL are arrangements that combine a spring loading system to our selkf shorting pins CA-1039 and CA-1060 having smooth body adapter. The recommend spring compression is not to exceed 0.25 inches maximum.