| Dynasen Inc. 20 Arnold Pl. Goleta, CA. U.S.A. 93117 Phone: (805) 964-4410, Fax: (805) 967-2824, email: dynasen@concentric.net |
| CA-1135 TRANSDUCER -THIS UNIT STILL UNDER DEVELOPMENT- As a reference please see our Model CA-1135 (Pictured here) |
||
| CA-1136 TRANSDUCER -THIS UNIT STILL UNDER DEVELOPMENT- As a reference please see our Model CA-1136 (Pictured here) |
||
| C101-50-4M50B PINDUCER Our Pinducer pin-like pressure transducer is an all-brass 50-Ohm coaxial construction arrangement that utilizes an axially-mounted half 1/4-watt carbon-composition resistor as its sensor. Its response (approximately 1/2 microsecond) is nearly independent of shock wave loading direction with an application range of 0-50Kbars (0-5 GPA). Because of its small diameter (.125 Inch), its ruggedness, and its relatively-low price, a Pinducer is a very convenient arrangement. It finds its greatest use in harsh environments (coarse or not well defined media), where most other types of sensors have been found to fail. Pinducers can be made of various lengths to accommodate most applications. Because of their high outputs they can used with DC or Pulse activated bridge schemes. See Dynasen's Pulse Power Supply unit. Pressure output calibration curves are available for data reduction. Please specify length upon ordering. |
| FLATPACK TRANSDUCERS A flat pack transducer, as its name suggests, is a long flat arrangement that utilizes one (or several) thin film sensor(s)-and-lead-assembly (ies) that is/are sandwiched between two relatively thick layers of an armoring material (metal, reinforced plastic Etc.) and connected to an output cable. The main purpose of the armoring is to protect the sensor and minimize its lateral straining. A flat pack is most useful in reconstituted or distended media (sand, dirt, concrete) where shock direction is well known. Therefore, flat packs can made using any type of single (or combination of) thin film stress sensors and numerous construction characteristics. Thickness can vary from 0.10 to 0.500 Inch and their lengths can range from a few inches to 20 Feet. In view of the large number of parameters to be specified for the construction of a flat pack, a part no will be assigned only after its type and physical characteristics are precisely defined by the requester. Please specify the type of application and ask for advice from Dynasen’s technical staff prior to ordering. |
