| Dynasen Inc. 20 Arnold Pl. Goleta, CA. U.S.A. 93117 Phone: (805) 964-4410, Fax: (805) 967-2824, email: dynasen@concentric.net |
To facilitate the use of Dynasens position transducers (Pins) and provide convenient means for connecting them to recording instrumentation, Dynasen currently manufactures feed through and cable assemblies that permit versatile and time-saving arrangements. Cable assemblies are found to be very convenient when large numbers of pins are used and experimental arrangements are such that soldering is difficult. Feedthroughs are also essential when tests are performed inside an evacuated chamber. Dynasen's connectors have been designed for quick and simple connect/disconnect operations, and high reliability. Cable ends can be terminated with a pigtail, an appropriate Dynasen connector a BNC connector or any combination of the above. High temperature cable (200 °C) is available at an additional cost for the construction of these cable assemblies. All cable used is made in the USA. To down load a PDF version of this page click (here) |
||
| CA-1144 Our feedthrough CA-1144 is a 7/16-HEX shaped housing and a 10-32 threaded body, vacuum tight arrangement that can be readily connected to our cable assembly model CA-1147-1, 1147-3, 1147-6. |
|||
| CA-1144-1 Our vacuum feedthrough Model CA-1144-1 with a 10-32 threaded body housing, is a lower cost arrangement that allows the same capability of our model CA-1144. |
|||
| CA-1148-1, CA-1146-2, and CA-1147-2 CA-1148-1, CA-1146-2, and CA-1147-2 |
|||
| CA-1148-2, CA-1146-3, CA-1147-4 These cable assemblies comprise 0.064in., 0.093in., or 0.125in. connectors respectively at one end and a BNC at the other end. Standard lengths are 1 to 6 feet. Other lengths available at an additional cost. |
|||
| CA-1147-1, CA-1147-3, CA-1147-6 These cable assemblies comprise either 0.064in., 0.093in., or 0.125in. connectors respectively at one and a 0.125in. connector at the other end. Standard lengths are 1 to 6 feet. Other lengths are available at an additional cost. |
|||
| CA-1148-3, CA-1146-4
CA-1148-3 and CA-1146-4 |
|||
